Original subtitles

In this lecture, we are going to see how to create splines and also we are going to see how to use

a tool called Connect.

Let us check it out.

You can see here I am in the sketcher interface of a new file, I'll go to insert profile spline.

You can see here these two options we are going to see.

Click on Spline.

Let us click somewhere here and here and here you can see what happens is.

We are creating some points and at the same time a tangential car passing through all the points is

getting created.

This tangential call is this plane.

A spline can be used for generating a tangential curve through point data, if you have point data and

you create the points, constrain the points, then you can just connect those points through a tangential

curve, through this blind tool.

Let us click here and I want to end this plane, so press on the escape Kittu exit from the plane.

Come on.

And you can see this plane has been generated.

Let us create another plane.

Take insert profile Spline.

Click on Spline.

You can see the resilience in his plane, just select the points.

Click somewhere here and I'll press the escape key to disconnect.

And create this plan, you can see that those planes have been created.

Now suppose we want to connect these two splines through it then, Schlocker, we can do that by using

the next tool called the Connect.

Click on Connect, select this plan and select this plan.

You can see here tangential curve has been generated.

Which is connecting these two planes.

If you want to connect any other car, maybe a line, let us select a line.

And maybe create the line here.

I'll take in third profile, Spline Connect, select this plane and maybe select this line, you can

see a tangential curve, which is tangent to both the curves has been generated through this connect

tool.

So if you want to connect any to cause it may be splines.

It may be line, it may be arc.

You just have to select, connect, select those two girls and a tangential curve connecting those two

kerswill regenerator.

So this is how we can create splines and use that to connect.