All language subtitles for 90_EN.

tutorial 90 assembly for Katia. In the previous tutorial we keep learning how to

position our parts and adding constraints and we use the constraint toolbox and

the manipulation toolbox and also we use another in the beginning is when we are

inserting a new part how you also can position it when you are inserting them

remember let's choose part 2 here and here you are every two position you

part as well so and here you can check either to make what you want to

constraint or not so we have different ways to position the parts and in this

tutorial we're going to show you another type for positioning using the

compass so in the beginner tutorials we show you how to translate the part

single part moving or treating it also you can do the same thing in the assembly

warp inch at a simple your far you usually compass for example add the compass

on that edge you just try it and add a picture to select that surface because when

you are throw it on the edge you're going to select that edge or the surface so

let's speak this surface and now you notice that we have different directions

where you can move your part for example if you double click on that and it's

changed direction to be 10 apply so you notice that you move that part so you

can again change to the direction you want apply so if you are so this is why

we got distance and you can take close also you can directly drag it the

direction you want here to and let's now take the compass back now let's try to

rotate the part let's add the compass on that edge and you can notice here

where you can rotate the part or double click to add a specific angle value

now you are satisfied with positioning you can't take it back again so after this

tutorial we now knew the different type of positioning as we showed you for

example at the beginning when you are assuming you are able to position your part

you have the constraint parts you have the manipulation and snap to the

and you have the compass and all it's spending on the user which method he

find it is easier or faster so I hope that was useful