Original subtitles

1

Twenty five scanning the top 20 in the top 100 ports within map.

2

So I'll remind you in our very first scan within map all we did was enter and map IP address now since

3

we didn't enter any port parameters in that particular IP scan by default and map scan the top DCP 1000.

4

So in this way it may be reasonable to scan for a single rope.

5

However it will not make sense to scan the entire network so therefore wouldn't be a good idea to scan

6

only specific ports when we want to scan.

7

So in this way we can scan faster and reduce the chance of catching the attention of security systems

8

and MAP offers many alternatives for scanning specific ports.

9

So let's have a look at the most used types of them one by one so if we type the command and map dash

10

dash top words 20 at a destination IP in the terminal and map or search for the top 20 DCP ports on

11

the target system.

12

Now you have to remember that in map always performs at DCP port scan if no specific parameters specified

13

so if you want to see what these 20 DCP ports are we can write and map dash dash top ports 20 V O G

14

V parameter means verbose Yogi parameter specifies that the scan result will be in grapple mode so we're

15

only going to see displayed the last dash parameter.

16

Similarly if you want to see the top 100 ports we can write and map dash dash top ports one hundred

17

V O G.

18

And similarly if you want to see the top 1000 ports we can write and map the oh gee we can do the same

19

thing by adding TCB parameters.

20

So what I mean by that we write and map S T dash dash top port 20 V O G so as t is the parameter that's

21

the DCP port then similarly if you want to see the top 100 ports right.

22

And map s top ports 100 the O.G. and then if we want to see the top 1000 ports we can write and map

23

as T V O G so let's do an example here over our virtual box of Kelly Linux and open at a split spoil

24

log into Kelly Linux v Ms and open up terminal and write this command and map 10 dot 0 dot dot dot for

25

s t top ports 20 V O G and press enter.

26

Now if we only want to see the port numbers and map s t top ports 20 the O.G. and press enter and if

27

you want to see what these 20 UDP ports are we can write and map as you top words 20 V O G now here

28

the ESU parameter is the UDP port and the v parameter is verbose the O.G. parameter specifies that the

29

scan result will be in grep able mode so it specifies that what will be displayed will be displayed

30

as the last parameter so similarly if you want to see the top 100 port we'll write and map as you top

31

ports 100 the O.G. and if you want to see the top 1000 boards will write and map s u v o g so we can

32

go back and open virtual box open Kelly Linux open exploitable and log in to Kelly Linux v Ms we can

33

open terminal and write the command and map then dot zeroed out to dot for as you top port twenty V

34

O G presenter and if we only want to see the port numbers and map s you top port twenty V O G and press

35

enter.