Original subtitles

Now unfortunately the font of the switch is very small and doesn't want to change all zoom in on the

video.

The kill switch has a large font.

And even though I change the font VIA OPTIONS preferences font and offset it to a large number

these twenty nine 60s I'm not changing the font.

So I'll simply zoom in on the video.

So my apologies if the resolution isn't that great why not configured these switches but on this Access

Switch what we need to do is we need to configure interface gigabit 0 1 as a trunk port so switch port

mode trunk that's come up but again don't forget to that sometimes you have to specify the encapsulation.

The switch doesn't allow you to specify the encapsulation it only supports dot one key so show interface

gigabit.

0 1 switch port shows us a vector the encapsulation used is edited at 1 Q So that's the encapsulation

that we're looking for the Porter's enabled and it's a trunk port so show villain.

Notice we're only seeing VLAN 1 in the and database show VTB status shows us that the switch is a server

number of airlines in the villain database is 5 typically a switch would learn the villains from the

kill switch.

So this port is a trunk port by default all V will be permitted the switch is not learning the V glands.

Now if you want to use VTB to distribute v lands what you need to do is set the VTB domain.

At the moment there is no domain name configured.

So what we could do is say V.P. domain and specify a domain such as CCMA.

So now show v DP status shows us that the VTB domain name is CCMA show v lan shows us that we've got

our v lands in the V land database and then if we have a look on switch one the access switch show v

lan shows that we still only have a villain one and the other default v lands on a real switch

the switch would learn and notice it has learnt that.

So show v LAN

and the switch in turn would learn the V lands.

So show v land here.

We still have our v lands and the v land database on the success switch hasn't learnt the V.

I'll set the mood to VTB client to see if that makes it any better.

I notice now it's learnt the villains in the real world.

A switch would learn the VTB domain like packet tracer did here but a server would still synchronize

with another server so the switch would have learnt the villains even if it hadn't been a client in

the exam they would be clearer about what to do with your villains so they would either tell you to

create them manually or to use VTB to learn the villains so switch one has now learnt the villains.

The next step is to go into forced Ethan at 0 1 and type switch port mode access switch port access

villain in this case 10 interface villain 1 the switch needs to have a IP address of tendered wondered

1

dot one configured on it no shut the villain.

So at this point it will hopefully be able to ping the core switch in the topology which it can.

So that's great.

The last thing you need to do is specify default gateway of tendered wondered 1 to 2 5 4 so the switch

should now be able to paying IP addresses in other v lines on the call switch which it can.

So again configuration was to set the villain to VLAN 10 on the access port we had to configure chunking

on the link to the call we configured a SBI an IP address on the SGI and we configured a default gateway

so that switch one configured.

Now we need to do something similar on switch to and switch 3.